Rubber Duck Super Cold RBE: Rubberised bitumen

Promac Rubber Duck Super Cold RBE is a single component rubberised bitumen-based quality product for damp proofing walls, floors, and foundations. It can also be used to seal ponds and dams and as a roof waterproofing membrane. It dries to form a tough, durable film which will accommodate small movement cracks and will withstand high temperatures without running or slumping. Forms an effective barrier to liquid water and water vapour.

• Environmentally friendly

• Extremely tough and flexible

• Forms a watertight system

• Good strength and elasticity

• May be overcoated with most Promac decorative paints

• Non-toxic after drying

• Safe for fish ponds once fully cured

• Ready for use

• Resists extreme temperatures

• Single component

• Very good resistance to abrasion, impact and stone chipping

This product will cover approximately 1 - 3 m² per litre per coat depending on the type of substrate, surface porosity and application method.

Prime the surface with the suitable primer product as suggested in SURFACE PREPARATION. Allow to dry.

STEP 1 - FIRST COAT
Apply one undiluted coat of Promac Rubber Duck Super Cold RBE at a rate of 1 - 3 m² / litre . Allow drying for 4 hours before recoating. If used in conjunction with a membrane do not allow to dry and embed the membrane whilst first coat is still wet.

STEP 2 - BEDDING (JOINTS, PONDS, DAMS & WATER FEATURES)
Thoroughly work the non-woven polyester fabric (waterproofing membrane) firmly into the still wet first coat to obtain maximum saturation from below, smooth out all air pockets and creases. Ensure a minimum of 50 mm overlap on the adjoining lengths of the membrane. Allow to dry until tacky before applying the saturation coat.

STEP 3 - SATURATION
Apply a saturation coat of Promac Rubber Duck Super Cold RBE at a rate of 1 - 3 m² / litre to completely obliterate the weave and pattern of the membrane. Allow to dry for 4 hours before recoating.

STEP 4 - FINISHING
Apply a final coat of Promac Rubber Duck Super Cold RBE at a rate of 1 - 3 m² / litre. Allow the finishing coat to dry for 12 hours before overcoating or 7 days before water exposure. If exposed to UV, Promac Rubber Duck Super Cold RBE must be overcoated with a suitable Promac top coat.

Do not allow the product to dry on equipment. Equipment is readily cleaned using water. (Some detergent may be added to water to facilitate clean up).

5 L & 20 L