Flex-E Proof

  • Ecoat Flex-E Proof is an acrylic waterproofing system comprising of a combined saturator, sealer and topcoat used in conjunction with a membrane (reinforcing polyester fabric). Prevents water ingress into roofs, parapet capping, masonry walls and seals cracks / holes where leaks may occur. Ecoat Flex-E Proof can be used to treat difficult areas where conventional waterproofing is required.

    • Excellent adhesion to suitably prepared surfaces

    • Forms a watertight system with the membrane

    • Low density system: Does not add excess weight to structures

    • May be overcoated with quality acrylic topcoats

    • Non-toxic

    • Tough and flexible

      Water clean-up

  • This product system will cover approximately 2.5 litre/m² depending on the type of substrate and surface porosity. Spread rates are based on the product being applied to sound smooth plaster.

  • Roofs, roof screws, flashings, joints, walls, parapets and capping: Apply Ecoat Flex-E Proof thickly at a rate of approximately 2.5 litres per m². For effective waterproofing properties, it's recommended that Ecoat Flex-E Proof be overcoated using a quality exterior coating. Use with waterproofing membrane.

    Follow instructions for a trouble-free application and long-lasting durability:

    Step 1 - Prime: Apply one coat of Ecoat Flex-E Proof to areas of the prepared surface slightly wider than the membrane at a rate of 1.0 litre per m², subject to the surface profile.

    Step 2 - Bedding: Thoroughly work the membrane firmly into the still wet Ecoat Flex-E Proof to obtain maximum saturation from below, smooth out all air pockets and creases. Ensure a minimum of 50mm overlap on the adjoining lengths of the membrane.

    Step 3 - Saturation: Immediately apply a coat of Ecoat Flex-E Proof to complete the saturation of the membrane and overlaps at a rate of 1.0 litre per m².

    Step 4 - When touch dry, apply a final top coat of Ecoat Flex-E Proof at a rate of 0.5 litre per m². Protect from rain until dry.

  • Clean all tools (brushes & rollers ) while wet with water after use.

  • 5 L & 20 L

Colours